Roller Shutter Doors Cape Town CBD

Western Cape

Suburbs we cover here: Woodstock, Salt River, Sea Point, Paarden Eiland

The Cape Town CBD is dense, old and heavily altered, and the doors reflect that: shopfront shutters on Long and Bree, back-of-house delivery openings off the service lanes, and basement parking entrances under buildings that have been converted more than once.

What we see in Cape Town CBD

Everything here is specified by how often it moves. A frontage that comes up at seven and down at six runs to around seven hundred cycles a year, and a curtain and bearing set built for a domestic garage will not survive it. We ask about the daily cycle before we ask about the width, and we spec the bearings, the slat gauge and the motor from that answer.

The buildings are the other half of the job. A single CBD opening can be original stock brick on one side, later concrete infill on the other and a steel lintel across the top, so we test-fix into the reveal before quoting rather than after. Where the substrate will not carry the load a steel sub-frame spreads it, and that goes on the quote as its own line so you can see what it is and why.

Getting on site in Cape Town CBD

Access in the inner city means working around trading hours and a service lane that is rarely empty, so we fit early where we can rather than costing you a day. The survey covers the reveal at three heights and a test fixing into the wall, because these openings have been altered more than once and what the wall is actually made of decides how the door is fixed.

Motors, backup and load shedding

On an inner-city shutter the motor is specified by cycle count, not by width. A motor rated for a domestic garage on a frontage that moves twice a day every day will run hot and fail inside a few years. We fit backup so an outage does not stop you opening or locking up, and we put the manual override somewhere reachable — on a trading premises that is the difference between locking up and waiting for us.

Repairs on any make

We repair any make, including plenty we did not build, and a shutter that will not close is treated as urgent because you cannot lock up. Most of those are a jammed bottom rail or a guide knocked by a delivery vehicle and are fixed on site the same visit. On the slower list it is bearings and motors specified for a domestic duty that have been working a trade cycle for years.

What it costs

We quote from a measured survey and the survey is free anywhere in the metro. What moves the price is the size of the opening, the slat gauge the job actually needs, whether it is motorised, the corrosion specification your address genuinely requires, wind locks and bracing where the opening is exposed, and whether the reveal needs making good first. We itemise those rather than handing you one number, so you can see what you are paying for and take out anything you do not want. A rough width and height over the phone is enough for a ballpark; we confirm it on site before anything is built.

How soon we can be there

Breakdowns in Cape Town CBD are attended same-day wherever we can reach you, and our teams work the metro every day. A door that will not close is treated as urgent. For new work the survey is normally within a day or two of your call, manufacture takes a few working days because every curtain is built to your measurements at our own works, and installation is a morning for a single and most of a day for a double or a wide opening with automation.

Getting a quote in Cape Town CBD

Send us the opening width and height — and on older stock, the width at the top and at the bottom if you can get both — along with a photo of the opening from a few metres back. Tell us roughly how far you are from the sea while you are at it, because that decides the finish. From there we book the free measured survey in Cape Town CBD, confirm the sizes ourselves, and put a fixed price in writing with the corrosion specification itemised. Nothing is built until you have agreed that price.